Hoover S3239 - Manual (Page 17)

Secondary filter
To clean secondary filter
Disconnect cleaner from electri-
cal outlet.
The secondary filter protects the
motor from dirt particles. If the
filter becomes dirty, either clean
or replace it.
To remove secondary filter, open
cover of cleaner and lift filter off
of motor housing. Clean filter by
rinsing it in water. When dry,
position filter around motor hous-
ing with notched edge at the bot-
tom and to the back of the motor
housing.
The belt
The belt in your electronic power nozzle drives the agitator. It has been
designed specifically for use in this cleaner and is important for effective
operation. There are other belts manufactured that are similar in shape
and size but are not designed for the HOOVER electronic power nozzle.
Such belts do not operate the agitator correctly and may create stress
which could damage your electronic power nozzle. Use only a genuine
HOOVER Belt No. 38528-011 when a belt replacement is necessary.
When to replace the belt on electronic power nozzle
The belt, located under the nozzle cover, should be replaced if the
“CHECK BELT” light remains “ON”. To service, remove the nozzle
cover (see following section).
How to replace the belt
Disconnect cleaner from electri-
cal outlet and disconnect elec-
tronic power nozzle from exten-
sion wands.
Turn nozzle over and unscrew
the 2 Phillips head screws from
the nozzle base.
15