Haan MS-30 - Manual (Page 24)

pg 22 877-HAAN DIRECT / 877-422-6347 www.haanusa.com
Using Your STEAM SYSTEM II
Fig 41
Using the Attachments:
(cont)
To attach and use accessories: (cont)
6) Push the attachment of choice onto the end of
the Concentrator Nozzle until it is firmly attached.
It will be a tight fit. The end of the nozzle is
shaped to fit the interior of each attachment
snuggly and you can change their position
around the nozzle to reach exactly the spot you
need to focus the steam (Fig 40).
7) Each of the small accessories (Angled Nozzle,
small round brushes, and the large Round Brush
attachment with, or without the steel wool) fit
onto the end of the Concentrator Nozzle in the
same way to concentrate your celaning with steam.
MicroCham ™ Towel & Sponge:
With the cleaning power of our Ultra-Microfiber on
one side and the super absorbency of our specially-
developed chamois on the other, these make clean-
quick and easy. Use the steam to clean and sanitize
surface areas and wipe any excess moisture up with
either the towel or sponge (Fig 41).
Garment/ Flat Surface attachment and Ultra-Microfiber
Cleaning Sock:
Use the Garment/Flat Surface Attachment alone for
steaming out wrinkles in clothing, sanitizing upholstery,
bedding and soft surfaces (Fig 42).
Attach the Cleaning Sock to the Garment/Flat Surface
Attachment to clean counter tops and other hard
surfaces to provide another means to sanitize kitchens
and bathrooms.
1) Follow the directions for attaching the Garment/
Flat Surface Attachment to the Steam Jet Nozzle
as you would the Concentrator Nozzle from
pg 21, steps 1-4. Be sure to lock the attachment
onto the Steam Jet Nozzle before using it to steam
away wrinkles and sanitize soft surfaces.
2) By attaching the Cleaning Sock the steam will
sanitize flat surfaces and absorb excess moisture
in one swipe.
Fig 40
➟
Shaped
Nozzle
End
Fig 42
!
i
CAUTION
The MS-30 emits steam at
212˚F to sanitize the area
of use. The attachments get
very hot during use. Care
should be taken when using
this appliance and DO NOT
touch the attachmants
during use except in the
approved manner as
outlined in this manual.