Haan MS-30 - Manual (Page 12)

Using Your STEAM SYSTEM II
pg 10 877-HAAN DIRECT / 877-422-6347 www.haanusa.com
1) Remove all parts from the packaging.
2) Assemble the unit as described on page 6,
attaching both extension poles (a & b)and the
Steam Head (c).(Fig 1)
3) Place the STEAM SYSTEM II canister on a flat,
level surface.
4) Place the STEAM SYSTEM II Steam Head on the
black Floor Protector Mat; be sure the “bumpy”
side is facing up(Fig 2). Never rest the Steam
Head on an unprotected surface
5) Remove the Water Tank Cap. The tank becomes
pressurized with use so you will need to press
down as you turn at first. After the first couple of
turns you will be able to remove the cap easily.
The fill cup included with your MS-30 holds 450 ml
/15 oz of water. Using the provided fill cup, pour
one cupful of water at a time into the tan through
the fill hole. DO NOT fill the cup above the 450 ml
line. A funnel is provided among the accessories to
help eliminate spillage. Depending on how long you
intend to steam, you may add additional water to
have a maximum of 900ml/30 oz. (2 fill cups) of
water in the tank without overfilling. (Fig 3)
NOTE: 296ml/10 ounces of water will give you about
15 minutes of steam while 591ml/20 ounces of water
will provide approximately 30 minutes of steam.
Do not overfill. You can see the water level by
looking into the opening to the Water Tank. You do
not want to allow the water level to come above
the threads in the screw opening.
IMPORTANT: One problem with a steamer
appliance is the mineral deposits caused by the
high mineral content in many municipal water
supplies. Mineral residue inside of the internal
system and heater can cause intermittent steaming
or, in some cases, no steam at all.
To reduce or eliminate the occurrence of mineral
deposits, we recommend the use of de-mineralized
or distilled water in the unit. However, regular tap
water may be used.
6) Replace the cap tightly when you have finished
filling the water tank.
Using the STEaM SYSTEM II to sanitize your floor:
Fig 1
Fig 2
Fig 3
Opening to
Tank
Always be sure that your
STEAM SYSTEM II is
UNPLUGGED from the wall
receptacle prior to filling the
water tank.
IMPORTANT
!
i
a
b
c
➟