Haan MS-30 - Manual (Page 14)

detach the pad from the Steam Head. The pad
and unit are specially designed for this ‘No Touch’
method of removal.
IMPORTANT NOTE: The Ultra-MicroFiber Pad gets
very hot from the steam during use. Allow it to
cool before removal.
14) Store the unit upright in a protected dry area,
resting the Steam Head on the Floor Protector/
Resting Mat.
Special Notes on Using your HAAN
®
STEaM
SYSTEM II as a floor sanitizer:
• Always vacuum or sweep floor before sanitizing
to pick up any loose debris on the floor.
• The easiest way to use the machine is to tilt the
ergonomic pole to a 45˚ angle and clean slowly
2-3 yards at a time.
• Although we do not advocate the use of chemicals,
to remove stubborn stains from vinyl or linoleum
floors, you can pre-treat with a mild detergent
and some water before using the STEAM SYSTEM
II. Once the solution has softened the stain, the
pad should soak up the excess and the steam will
sanitize the area.
• Never leave the Ultra-MicroFiber Pad on your
STEAM SYSTEM II when you have finished using
the unit. Always remove the pad and wash it in
cool or warm water with a mild detergent. Never
use bleach or fabric softener. See further instructions
on the care of the Ultra-MicroFiber Pad on pages 12-14.
• One problem with a steamer appliance can be mineral
deposits caused by the high mineral content in
many municipal water supplies. Mineral residue
inside of the internal pipes, hoses,and heater can
cause intermittent steaming or, in some cases, no
steam at all.
To reduce or eliminate the occurrence of mineral
deposits, we recommend the use of de-mineralized
or distilled water in the unit. However, regular
tap water may be used.
Using the STEaM SYSTEM II
to sanitize your floor (cont):
Using Your STEAM SYSTEM II
pg 12 877-HAAN DIRECT / 877-422-6347 www.haanusa.com
!
i
CAUTION
The MS-30 emits steam at
212˚F to sanitize the area
of use. This means that
the steam head, Ultra-
MicroFiber Pads and
attachments get very hot
during use. Care should
be taken when using this
appliance and DO NOT touch
them during use except in
the approved manner as
outlined in this manual.