Using your steam system ii, Using the steam system ii – Haan MS-30 User Manual
Page 13
7) Plug the STEAM SYSTEM II into a convenient
standard 120-volt grounded wall receptacle.
8) Press the ON/OFF button ( ) on the canister
front to turn your STEAM SYSTEM II ON (it’s
inside the inverted orange triangle). The GREEN
Power ON light will illuminate as will the
ORANGE Ready Light. (Fig 4),
Your STEAM SYSTEM II is ready to use when the
ORANGE Ready Light deactivates after about 3-5
minutes, (should take no longer than 8 minutes)
indicating the unit is heated and ready to steam.
The amount of time is determined by the amount
of water added to the tank which will also
determine the duration time for use.
9) Place an Ultra-MicroFiber Pad on the floor with
the ‘hook & loop’ side facing up. Lightly press
the STEAM SYSTEM II Steam Head on the pad,
making sure the Ultra-MicroFiber Pad is centrally
positioned to the bottom of the unit. (Fig 5a & b)
The specially designed bottom of the MS-30
Steam Head will grip the pad.
10) Push and pull the MS-30 Steam Head slowly
across your floor to thoroughly steam clean
each section. (Fig 6)
To Refill Water Tank:
11) When you no longer have steam emitting from
the nozzle, this signifies that there is no more
water in the Water Tank. Rest the Steam Head on
the Floor Protector Resting Mat while you follow
the steps to refill the water tank.
12) To refill the water tank, turn your STEAM SYSTEM
II off and unplug it from the electrical wall outlet.
Let the unit depressurize for 30 seconds. Then
follow steps 5 - 8 to continue steaming.
13) Should the Ultra-Microfiber Pad become saturated or
soiled, you will want to replace it with a clean pad.
Turn the MS-30 OFF and wait until the unit and
pad cools down for approximately five (5) minutes
before removing the Ultra-Microfiber Pad from the
Steam Head. Remove the pad by using your foot
(Fig 7) to hold the pad while you pull up to
Using the STEaM SYSTEM II
to sanitize your floor (cont):
www.haanusa.com 877-HAAN DIRECT / 877-422-6347
pg 11
Never leave the Ultra-
MicroFiber Pad on your
STEAM SYSTEM II when
you have finished using
the unit.
Fig 7
Fig 4
Using Your STEAM SYSTEM II
Fig 5
b
a
Yes
NO!
Fig 6