HP ep7100 Series - Manual (Page 7)

User’s Guide 7
1
Setting up
Safety precautions
Å WARNING: Read and observe these precautions and all others in this manual to
reduce the risk of injury and equipment damage.
■ Do not look directly into the lens when the lamp is on.
■ Do not expose the projector to rain or moisture, and do not use it near water.
■ Keep paper, plastic, and combustible material at least 0.5 m (2 ft) away from
the projector lens and exhaust vents.
■ Do not allow liquid, food, or small objects to get inside the projector. If
material gets inside the projector, contact HP for assistance.
■ Do not put anything on top of the projector. Do not place any liquids where
they might spill on the projector.
■ Do not block any vents on the projector. Do not place the projector near any
source of heat, such as a radiator or amplifier.
■ Use only an approved power cord rated for the voltage and current marked
on the product label. Do not overload any outlet or extension cord. Do not
circumvent the grounding prong on the power cord.
■ Route all cables so they are not located where people can step on them or trip
on them.
■ Place the projector flat on its base on a sturdy surface or on an HP ceiling
mount. Do not stand the projector on its front surface.
■ Do not touch the lens with your fingers. See “Cleaning the projector lens” on
page 43. Use a soft, dry cloth to clean the projector case.
■ Do not open the projector except as instructed by this manual, and only after
allowing the projector to cool down.
■ If the projector is damaged in any way, contact HP for assistance.