HP LASERJET 9000MFC - Manual (Page 91)

A Specifications 91
Paper specifications
Labels
To avoid damaging the product, use only labels recommended for use in monochrome laser printers. Never
print on the same sheet of labels more than once.
CAUTION Do not print on both sides of labels, transparencies, envelopes, custom paper, or paper heavier than
216 g/m
2
(58 lb bond). Damage to the product and jams might result.
L abel construction
When selecting labels, consider the quality of each component:
l Adhesives: The adhesive material should be stable at 200° C (392° F), the maximum fusing temperature
of the product.
l Arrangement: Only use full-sheet labels. Labels can peel off sheets with spaces between the labels,
causing serious jams.
l Curl: Prior to printing, labels must lay flat with no more than 13 mm (0.5 inch) of curl in any direction.
l Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
Transparencies
CAUTION Transparencies used in the product must be able to withstand 200° C (392° F), the maximum fusing
temperature of the product. To avoid damaging the product, use only transparencies recommended for
use in monochrome laser printers.
Do not print on both sides of labels, transparencies, envelopes, custom paper, or paper heavier than
216 g/m
2
(58 lb bond). Damage to the product and jamming might result.
If you have problems printing transparencies, use Tray 1 and send them to the face-down bin.
ENWW