Henny Penny 323 - Manual (Page 8)

Model OFE/OFG-321,322,323,324
2-11. TESTING THE FRYER
Each Henny Penny pressure fryer was completely checked
and tested prior to shipment. However, it is good practice to
check the unit for proper operation.
2-12. JOINING INSTRUCTIONS
The following instructions are for joining two units together.
The instructions have part numbers in them. Please refer to
figure 2-1 on the following page to visually match the
numbers in the instructions below to the illustration.
1. Remove all hardware from the sides of the two open
fryers.
2.
Remove the right control panel assembly from the left
unit and the left control panel assembly from the right
unit.
3. Move the two units side by side with minimal gap.
4. Remove the right front caster from the left unit and the
left rear caster from the right unit. Fasten both casters to
the rear of the unit with wire ties (EF02-041).
5. Position the two open fryers by inserting bolts
(SC01-227) thru the holes in top cover and the pot sides.
Use washer (WA01-017) on both sides of the bolt when
installing. DO NOT TIGHTEN!
6. Position front spacer (60554) between the front of the
two open fryers. Place bolt (SC01-231), backed by
washers (55350 & WA01-016), thru three holes in the
frame capturing the spacer between the frames. Place
washers
(55350 & WA01-016) on bolt before installing nuts
(NS02-010). DO NOT TIGHTEN!
7. Repeat with rear spacer (60555).
8. Tighten all fasteners securely.
9. Place cover (60593) over gap between open fryers.
10. Drill out dimples on rear shroud to 0.250 diameter holes.
11. Apply silicon around edge of unfinished side of rear
cover (60599). Install rear cover (60599) with #8 nuts
(NS02-007).
211 2-8