Hoshizaki KM-250BWF - Manual (Page 44)

44
14. Removal and Replacement of Float Switch
1) Go through the steps 1) through 9) in “13. Removal and Replacement of Pump
Motor.”
2) Remove the connectors of the float switch.
3) Remove the screw and the float switch bracket.
4) Remove the two screws and the float switch.
5) Take off the hose sleeving the float switch leads.
6) Sleeve the leads of the new float switch with the hose.
7) Install the new float switch, and replace the removed parts in the reverse order of
which they were removed.
8) Go through the steps 15) through 17) in “13. Removal and Replacement of
Pump Motor.”
15. Removal and Replacement of Spray Tubes
1) Turn off the power supply, and unplug the icemaker.
2) Remove the front panel, top panel and top insulation.
3) Disconnect the hoses.
4) Lift off the spray tubes.
5) Install the new spray tubes.
Note: Place the spray tubes so that the holding tabs on both sides are in position.
6) Connect the hoses.
7) Replace the top insulation, top panel and front panel in their correct positions.
8) Plug in the icemaker, and turn on the power supply.
13) Install the new pump motor, and replace the removed parts in the reverse order
of which they were removed.
14) Close the bin door.
15) Replace the panels in their correct positions.
16) Plug in the icemaker, and turn on the power supply.