beautypg.com

Listing and code approvals – Hearth and Home Technologies BIR42 User Manual

Page 5

background image

5

1

1

Listing and Code Approvals

Notice: This fi replace is tested and approved as a decorative
fi replace. It should not be factored as a primary heat source
in residential heating calculations.

WARNING! Risk of Fire! Hearth & Home Technologies
disclaims any responsibility for, and the warranty and
agency listing will be voided by the actions below.
DO NOT:

• install or operate damaged fi replace

modify

fi replace

• install other than as instructed by Hearth & Home

Technologies

operate

the

fi replace without fully assembling all

components

overfi re

• install an unvented gas log set

• install any component not approved by Hearth &

Home Technologies

• install parts or components not Listed or approved

Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.

For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.

B. Non-Combustible Materials

• Materials which will not ignite and burn, composed of any

combination of the following:
- Steel

-

Iron

- Brick

- Tile

- Concrete

- Slate

- Glass

- Plasters

• Materials reported as passing ASTM E 136, Standard

Test Method for Behavior of Metals, in a Vertical Tube
Furnace at 750° C

C. Combustible Materials

• Materials made of or surfaced with any of the following

materials:
- Wood

- Compressed

paper

- Plant

fi bers

- Plastic

• Any material that can ignite and burn; fl ame proofed or

not, plastered or un-plastered

Heatilator • Birmingham BIR42 • 4059-308 Rev E • 08/08

A. Appliance Certifi cation

This fi replace system has been tested and listed in accor-
dance with UL 127 standards by Underwriters Laboratories
Inc. for installation and operation in the United States.

This fi replace may be installed in sleeping rooms EXCEPT
in manufactured homes. If installed with a gas log set, pro-
visions for the National Fuel Gas Code must be met.

This fi replace has been tested and listed for use with
the optional components specifi ed in this manual. These
optional components may be purchased separately and
installed at a later date.

NOTICE: The outside air kits must be installed at the time of
fi replace installation.

Heatilator is a registered trademark of Hearth & Home
Technologies Inc.