HP Pavilion ze5300 - Manual (Page 126)

11.
12.
13.
14.
Remove the four M5.0×10.mm standoffs from the notebook rear panel (two on each side of the
parallel and external monitor connectors).
Remove the three M2.5×6.0 mm screws that secure the CD/DVD drive rear alignment rail to the
bottom case.
Remove the CD/DVD drive rear alignment rail.
Remove the two screws that secure the CD/DVD drive front alignment rail to the bottom case.
Note
The two screws that secure the CD/DVD drive front alignment rail to the bottom case are two
different sizes. The screw that secures the left side of the rail is a M2.0×4.0 mm screw. The screw
that secures the right side of the rail is a M2.5×6.0 mm countersink screw. Make sure these
screws are installed in the correct locations when reinstalling the CD/DVD drive front
alignment rail.
15.
16.
17.
18.
19.
20.
Remove the CD/DVD drive front alignment rail.
Remove the two M2.5×6.0 countersink screws (one on the front edge of the motherboard, the other
on the left edge of the motherboard) that secure the motherboard to the bottom case.
Remove the two M2.0×5.0 screws that secure the motherboard to the bottom case on the back edge
of the motherboard.
Remove the antenna cable from the metal holder on the motherboard.
Carefully lift the motherboard out of the bottom case.
If present, remove the modem port cover.
Service Manual Removal and Replacement 2-55