HP Pavilion ze5300 - Manual (Page 113)

Note
This section applies only to HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500
models.
Required Equipment
• #0 Phillips screwdriver.
Removal Procedure
1.
2.
3.
4.
5.
Unplug the AC adapter, if present, and remove the battery.
Remove these additional assemblies:
• Hard disk drive (page 2-9).
• Keyboard cover (page 2-12).
• Keyboard (page 2-16).
• Switchboard PCA (page 2-18).
• Display assembly (page 2-23).
• Top case (page 2-26).
Disconnect the two fan cables from the motherboard.
Remove the four retaining M2.0×5.0 mm screws in the “1”, “2”, “3”, “4” sequence stamped on the
heat sink.
Lift up on the heat sink (with fan).
Figure 2-27. Removing the Heat Sink (with Fan)
HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500 Models
2-42 Removal and Replacement Service Manual