HP CheXpress CX30 - Manual (Page 11)

CheXpress® CX30 User’s Manual_Rev 020309
11
How to Load Checks
CX30 – The manual ‘drop & slide’ feeder takes just one check at a time. Use the
following directions:
1. Remove all rubber bands, staples, paper clips, pins, etc.
2. Hold the item with the front of the item facing out and away from the scanner
(see Fig 8).
NOTE: Checks must be inserted flat into the entry tray and slide forward until it stops or
is pulled into the scanner.
3. The status LED should momentarily turn ‘Orange’ and the motor should start and
take the check into the path.
4. Depending upon the scan mode selected by the application and the open or
closed position of the exit door, the document will either scan through the unit
and stop in the exit door or scan and return back to the entry tray for easy
removal.
Fig. 8