Hitachi JPEG2000 - Manual (Page 32)

JPEG2000 Stand alone DVR User Guide
- 32 -
4-3-6 Event popup setup
1.[CHANNEL]
Use [+] and [-] to select a channel.
2.[POPUP ON/OFF]
Set up the POPUP function ON/OFF: Use [+] and [-] to select ON or OFF. When
there is an event, the screen display will switch to a full screen of the corresponding
channel.
3.[EVENT]
Use [+] and [-] to select the event type that will trigger the POPUP:
A- Alarm / M- Motion / AM- Alarm or Motion.
4.[DURATION]
Use [+] and [-] to set up a duration of the POPUP. The setting range is from 1
second to 60 seconds. When the Event POPUP finishes, 4CH DVR returns to
its Quad screen display, 8CH DVR 9 -Split screen display, and 16CH DVR
16-Split screen display.
4-3-7 Buzzer setup
Set up the condition that triggers the buzzer to beep. Use [UP] and [DOWN] to select
an itme and press ENTER to turn ON or OFF the selection.
1.[ALL]
Turn ON or OFF of all the conditions that tigger the buzzer to beep.
You can also setup the buzzer by the conditions. Move the cursor to the
desired selection and press ENTER to turn ON or OFF the selection.
2.[KEY BEEP]
Turn on/off the beep while operating the front panel.
3.[VIDEO LOSE]
Turn on/off the beep at the video lose.
4.[ALARM ACTIVE]
Turn on/off the beep when an alarm is triggered.
5.[MOTION DETECT]
Turn on/off the beep when motion is detected.
1. When the buzzer is triggered to beep, press any button on the front panel to turn off the
Beep.
2. The beeping can only be turned off manually. There is no time out setup to turn off the
Beeping automactically.