Harbor Freight Tools 67139 - Manual (Page 22)

SKU 67139 For technical questions, please call 1-800-444-3353. Page 22
area selectiOn
This sub-menu shows the camera’s
view broken up into a grid. You
choose which sections of the image
detect motion.
To set individual blocks of the screen:
1.
Press the arrow keys [ a. , , and
] to select a block in the grid
Press the [SEL] button to toggle be- b.
tween showing the image in the block
(motion is detected where the image
can be seen), or shading the image in
the block (motion will not be detected
in theses areas).
To disable all areas of the screen
2.
from detection, press STOP . The
screen will be completely shaded.
To have all of the camera’s viewing
3.
area detect motion, select QUAD. All
of the screen will be in view.
Press [MENU] to exit sub-menu.
4.
Press [MENU] twice more to go back 5.
to the Main Menu.
hard drive setup
The Hard Drive Setup sub-menu al-
lows you to set whether to overwrite
old video once the hard drive is full,
and it allows you to format the hard
drive.
It also shows hard drive size and how
much memory is used.
In the Main Menu, press the up or
1.
down arrow keys [ , ] to select
“Hard Drive Setup”.
Press [SEL] to enter the Hard Drive
2.
Setup sub-menu.
Overwrite enable/disable
hard drive setup
OVERWRITE ENABLED [ ON]
MAXTOR STM250310AS
MASTER HDD SIZE 250203MB
MASTER HDD USED 124931MB 50%
MASTER HDD FORMAT
SLAVE HDD SIZE N/A
SLAVE HDD USED N /A
SLAVE HDD FORMAT
( )MOVE ( SEL)SELECT (MENU)EXIT
1. In the Hard Drive Setup sub-menu,
press the arrow keys [ , ] to select
“Overwrite Enabled”.
Press [SEL] to switch between the
2.
“ON” which will overwrite the oldest
video when the hard drive is full, and
“OFF” which will stop recording when
the hard drive is full.
master hdd FOrmat
In the Hard Drive Setup sub-menu, 1.
press the arrow keys [ , ] to select
“Master HDD Format”.
Press [SEL] to Format the hard drive.
2.
This will erase all recorded video
from the hard drive and will make the
hard drive readable by the DVR.
You will be prompted for a password
3.
before formatting. The default pass-
word is “111111”.