HP ProLiant Blade BL460c - Manual (Page 32)

HP Smart Array E200i
Controller Disk Drive and
Enclosure Interface 3G SAS (Serial Attached SCSI)
1.5G SATA (Serial Advanced Technology Attachment)
Cache Memory Speed DDR-1/266 MHz provides up to 4.2 GB/s maximum bandwidth.
Server Interface x4 2.5G PCIe provides 2GB/s maximum bandwidth.
SAS Speed x2 3G SAS provides 600MB/s maximum bandwidth.
Cache Memory 40-bit 64MB or 128MB cache: ECC protection, battery-backed, and
transportable
Logical Drives
Supported Up to 32 logical volumes
Maximum Logical Drive
Capacity 144GB (2 x 72GB)
Host Memory
Addressing 64-bit, supporting greater than 4GB server memory space
RAID Support RAID 5 (Distributed Data Guarding) requires 128MB BBWC option
RAID1, 1+0 (Striping & Mirroring)
RAID 0 (Striping)
Upgradeable Firmware Upgradeable Firmware
Embedded NC373i
Multifunction Gigabit
Server Adapter Network Processor Broadcom 5708S
Data Transfer Method Four lane (x4) PCI Express
Network Transfer Rate 1000 Mb/s half duplex (theoretical maximum value)
NOTE: The Gigabit Ethernet adapters above transmit from the server
only at 2000 Mbps, full duplex per port. For more information, see the
"Network Controller" segment in the Standards Features section.
IEEE Compliance 802.1p, 802.1Q, 802.3, 802.3ad, and 802.3x
Standard Features TCP/IP offload engine (TOE) for Microsoft Windows
iSCSI Boot for Linux
9K jumbo frames
TCP/IP checksum offload (TCO)
Large send offload (LSO)
Interrupt coalescence
Dual address cycles (DAC)
Wake-on-LAN (WOL)
Pre-boot execution environment (PXE)
ProLiant Teaming including Network Fault Tolerance, Transmit
Load Balancing, and Switch-Assisted Load Balancing
IPv6 packet transmit and receive (excluding all offload
capabilities); IPv6 aware SNMPv1 agents for Windows
QuickSpecs
HP ProLiant BL460c Server Blade
Technical Specifications
DA - 12518 U.S. QuickSpecs — Version 27 — 5/12/2008 Page 32