Heat & Glo Fireplace HEAT & GLO Escape-42DV - Manual (Page 33)

Heat & Glo • Escape-42DV • 2052-900 Rev. Y • 11/11 33
C. Installing Non-combustible Facing Material
Figure 9.3 Complete Installation of Non-combustible Facing
Material
Fire Risk.
• Follow these instructions exactly.
• Facing materials must be installed properly to
prevent fi re.
• No materials may be substituted without
authorization by Hearth & Home Technologies.
Figure 9.2 Attaching Non-combustible Facing Material
60 in.
43 in.
NON-COMBUSTIBLE
ZONE
APPLY FASTENERS
FROM FASTENER PACKET
IN THESE AREAS
NON-COMBUSTIBLE
FACING MATERIAL
(9 IN. WIDE, SUPPLIED ATTACHED TO
BACK OF APPLIANCE)
NO FASTENERS
IN THIS AREA
2 IN.
9 IN.
1 IN.
WARNING
• Center and attach two top boards to the framing
members. See Figure 9.2.
• Attach left and right side pieces to framing members.
• Use fasteners from fastener packet (in manual bag) in
shaded areas.
• Use regular sheetrock screws in non-shaded areas.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• Apply a non-combustible adhesive to attach tile,
stone or other non-combustible fi nishing materials per
manufacturer’s instructions.