HP ProLiant ML330 - Manual (Page 33)

Data Transfer Rate Sustained 150 KB/s (single), 1,500 to 7,200 KBps
(10x to 48x)
Burst 150 KB/s to 7,200 KB/s
Cache Buffer 128 KB
Start-up Time (typical) <7seconds
Stop Time <4seconds
Laser Parameters Type Semiconductor Laser GaA1As
Wave Length 780 ± 25 nm
Operating Conditions Temperature 41° to 113° F (5° to 45° C)
Humidity 10% to 80%
Dimensions (HxWxD, maximum) 1.7 x 5.85 x 8.11 in (42.9 x 150 x 208 cm)
Weight 2.09 lb (0.95 kg)
NC7760 PCI Gigabit
Server Adapter
(embedded) Network Interface 10Base-T/100Base-TX/1000Base-TX
Compatibility IEEE 802.3 10Base-T
IEEE 802.3ab 1000Base-T
IEEE 802.3u 100Base-TX
Data Transfer Method 32-bit bus-master PCI
Network Transfer Rate 10Base-T (Half-Duplex) 10 Mb/s
10Base-T (Full-Duplex) 20 Mb/s
100Base-TX (Half-
Duplex) 100 Mb/s
1000Base-TX (Half and
Full-Duplex) 2000Mb/s
Connector RJ-45
Cable Support 10Base-T Categories 3, 4 or 5 UTP; up to 328 ft (100 m)
10/100/1000Base-TX Category 5 UTP; up to 328 ft (100 m)
Integrated Single
Channel Wide Ultra3
SCSI Adapter in PCI
Slot 1 Drives Supported Up to 14 SCSI devices Wide Ultra320, Wide Ultra3 and Wide Ultra2
SCSI hard drives
Data Transfer Method 64-bit/33-MHz PCI bus-master
SCSI Channel Transfer
Rate 160 MB/s per channel
Maximum Transfer
Rate per PCI Bus (peak) 267 MB/s per channel
SCSI Protocols Wide Ultra 3 SCSI and Wide Ultra2 SCSI
Electrical Protocol Low Voltage Differential (LVD)
SCSI Termination Active Termination
External SCSI
Connectors External SCSI cabling from the integrated SCSI controller is achieved
using an internal to external SCSI cable option kit (PN 159547-B22 or
333370-B21).
Internal SCSI
Connectors One 68-Pin Wide Ultra SCSI-3 connectors
QuickSpecs
HP ProLiant ML330 Generation 3
Technical Specifications
DA - 11614 Worldwide QuickSpecs — Version 44 — 6.28.2005 Page 33