HP WHR-HP-AG108 - Manual (Page 8)

1. Power down the Cable or DSL modem and the computer which will be used to
configure the AirStation router.
2. Plug the Cable or DSL’s LAN Ethernet cable into the AirStation’s WAN port. Initially,
you may need to unplug this cable from your computer, hub or other router.
3. Plug the provided Ethernet cable into a LAN port on the AirStation and plug the other
end into your computer’s Ethernet adapter (NIC). If you plan to initially configure the
AirStation wirelessly (not recommended), you may skip this step.
4. Power on your cable or DSL modem and wait one full minute, then power on the
AirStation router and wait one full minute, and finally power on the computer which
will be used to configure the AirStation. If the red DIAG light on the AirStation is lit or
flashing after several minutes of being powered on, please consult Buffalo Technology
Technical Support.
Connecting your AirStation