HP HDX 16 - Manual (Page 87)

Removal and replacement procedures 4–52
TV tuner module cable
✎
The TV tuner module cable is included in the Cable Kit, spare part number 496481-001.
Before removing the TV tuner module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see “Battery” on page 4-8 ).
5. Remove the following components:
a. Optical drive (see “Optical drive” on page 4-9 )
b. Hard drive (see “Hard drive” on page 4-11 )
c. TV tuner module (see “TV tuner module” on page 4-13 )
d. Memory module (see “Memory module” on page 4-15 )
e. WLAN module (see “WLAN module” on page 4-16 )
f. Switch cover (see “Switch cover” on page 4-18 )
g. Keyboard cover (see “Keyboard cover” on page 4-20 )
h. Keyboard (see “Keyboard” on page 4-24 )
i. Speaker assembly (see “Speaker assembly” on page 4-30 )
j. Display assembly (see “Display assembly” on page 4-31 )
k. Top cover (see “Top cover” on page 4-39 )
l. Audio/infrared board (see “Audio/infrared board” on page 4-50 )
Remove the TV tuner module cable:
1. Remove the TV tuner module cable connector 1 from the clip in the base enclosure.
2. Remove the TV tuner module cable 2.
Reverse this procedure to install the TV tuner module cable.