beautypg.com

Warning – Hearth and Home Technologies GARNET-MBK User Manual

Page 26

background image

Page 26

September 1, 2008

Quadra-Fire · Garnet-T · 7016-127F

A

B

C

Mounting Screws

Pressure Regulator Tower

Diaphragm

Figure 6.5

Turn control knob to the OFF position, ensure that

gas supply to the valve has been turned off. Using a Torx
TH20, or slotted screwdriver, remove the three pressure reg-
ulator mounting screws (A), pressure regulator tower (B),
and diaphragm (C).

2. Valve Regulator Replacement

Remove upper and lower back shield. Loosen the set col-
lars on the extension rods with the 3/32 in. Allen wrench.
Remove the rods and adapter cap.

Fire Risk.
Explosion Risk.
Disconnect any electrical cords and

turn off gas supply to unit before
proceeding if converting fuel on an
appliance already fully installed.

WARNING

Fire Risk.
Explosion Risk.
If the information in these instructions is

not followed exactly, a fire, explosion or
production of carbon monoxide may result
causing property damage, personal injury
or loss of life.

The qualified service agency is responsible

for the proper installation of this conversion
kit. The installation is not proper and
complete until the operation of the converted
appliance is checked as specified in the
manufacturer’s instructions supplied with
the kit.

WARNING

WARNING

Fire Risk.
Explosion Risk.
Gas Leak Risk.
• Rubber gasket must be seated properly on valve

face.

• Do no install a valve or regulator that has been

dropped.

E

D

F

Rubber Gasket

Screws

Identification Label

Figure 6.6

Ensure that the rubber gasket (D) is properly

positioned and install the new HI/LO pressure regulator
assembly to the valve using the new screws (E) supplied

with the kit. Tighten screws securely. (Reference torque =
25 in./lb.) Install the enclosed identification label (F) to the
valve body where it can be seen.

Fill out the conversion label and attach it to the valve cover.

This manual is related to the following products: