HP 441877-00B - Manual (Page 167)

Diagnostics 167
41. No external memory detected
42. DMA buffer %04X is large, size must be less than %04X
43. File size %d is too big, max is %d
44. Invalid %s
45. Failed writing 0x%x to 0x%x
46. *1
47. *1
48. *1
49. *1
50. Cannot perform task while chip is not running. (need driver)
51. Cannot open register define file or content is bad
52. ASF Reset bit did not self-cleared
53. ATTN_LOC %d cannot be mapped to %cX CPU event bit %d
54. %s Register is not cleared to zero after reset
55. Cannot start Register Timer
56. poll_ASF bit did not get reset after acknowledged
57. Timestamp Counter is not counting
58. %s Timer is not working
59. Cannot clear bit %s in %cX CPU event register
60. Invalid "EEPROM_FILENAME" file size, expected %d but only can read %d bytes
61. Invalid magic value in %s, expected %08x but found %08x
62. Invalid manufacture revision, expected %c but found %c
63. Invalid Boot Code revision, expected %d.%d but found %d.%d
64. Cannot write to EEPROM
65. Cannot read from EEPROM
66. Invalid Checksum
67. Invalid Magic Value
68. Invalid MAC address, expected %02X-%02X-%02X-%02X-%02X-%02X
69. Slot error, expected an UUT to be found at location %02X:%02X:00
70. Adjacent memory has been corrupted while testing block 0x%08x-0x%08x
Got 0x%08x @ address 0x%08x. Expected 0x%08x
*1 Internal Use. Program will not generate this error.
HP NC-Series Broadcom Multifunction adapter
diagnostics
Overview