HP 441877-00B - Manual (Page 165)

Diagnostics 165
o dflt = 1
• -rstpl
o = post GRC rst poll interval, dly in ms; dflt = 10
o = post GRC rst poll count; dflt = 0 (disable)
• -rstpld
Above post reset polling counts display enable.
• -addref (x)
Added a ref card info of dev to refinfo.txt
• -blink
Blinks the LED on the selected device
• -rf
Selects a reference device for test D3
• -sil
Used before the -firm and -firmall options to hide warnings
• -exe
Executes diags commands without a device present
• -updateasfcfg
Used with the -firmall option to include updating ASF CFG block
• -updateumpcfg
Used with the -firmall option to include updating UMP CFG block
• -pump
Option to program UMP firmware
• -updatesecfg
Used with the -firmall option to include updating SE CFG block
• -mfct
Programs a new SSID and SVID based on
• -fail2
On failure offsets failed message printout
• -logfl
Log file buffer flush per line
• -nosz
Do not write the NVRAM with the TPM/NVRAM size
Error codes and messages
1. Got 0x%08x @ 0x%08x. Expected 0x%08x
2. Cannot run test while chip is running
3. Invalid adapter device
4. Read only bit %s got changed after writing zero at offset 0x%X