HP 441877-00B - Manual (Page 121)

Adapter configurations 121
o Syntax: FORCEDUPLEX=n
Where n=
0–auto-negotiate
1–half-duplex
2–full-duplex
NOTE: To set the adapter to half- or full-duplex, you must set the SPEED parameter to either 10
or 100.
o Default: auto-negotiation
o Examples:
100 Mbps full-duplex: FORCEDUPLEX=2 SPEED=100
10 Mbps full-duplex: FORCEDUPLEX=2 SPEED=10
• SPEED. If no speed setting is specified, the adapter auto-negotiates the speed with the hub/switch,
either 10 or 100 Mbps. If the adapter and hub/switch are unable to auto-negotiate, the adapter
defaults to 10 Mbps.
o Syntax: SPEED=n (n = 10 or 100)
o Default: The adapter automatically senses speed.
Examples of system file settings
•
Example NET.CFG
Link Driver N100C32
NetWare DOS Requester
FIRST NETWORK DRIVE F
NETWARE PROTOCOL NDS BIND
Protocol IPX
IPX SOCKETS 40
Protocol TCPIP
IP_ADDRESS 201.201.202.25
IP_ROUTER 201.201.202.1
IP_NETMASK 255.255.255.0
PATH TCP_CFG C:\NW5C32\TCP
BIND N100C32
•
Example STARTNET.BAT for Client 32
SET NWLANGUAGE=ENGLISH
C:\NW5C32\NIOS.EXE
LOAD C:\NW5C32\NBI32.NLM
LOAD C:\NW532\LSLC32.NLM
LOAD C:\NW5C32\CMSM.NLM
LOAD C:\NW5C32\ETHERTSM.NLM
LOAD C:\NW5C32\N100C32.LAN FRAME=ETHERNET_II
LOAD C:\NW5C322\TCPIP.NLM
LOAD C:\NW5C322\TRANNTA.NLM
LOAD C:\NW5C322\IPX.NLM
LOAD C:\NW5C322\SPX_SKTS.NLM
LOAD C:\NW5C322\CLIENT32.NLM
•
Example CONFIG.SYS
DEVICE=C:\DOS\HIMEM.SYS
device=c:\dos\emm386.exe noems
DOS=HIGH,umb