Epson G10 Series - Manual (Page 27)

Setup & Operation 2. Specifications
G10 / G20 Rev.2 17
Reference hole
(Tolerance applies
to the pin hole)
Conical hole ø4,90°
1 mm flat cut
Max.ø18 through hole
ø25 h7 shaft diameter
90 or more
Space for cables
(*) indicates the stroke margin by mechanical stop.
ø39.5 mechanical stop diameter
Detail of “A”
(Calibration point position of Joints #3 and #4)
Reference through hole
(View from the bottom of the base)
Detail of “B”
G10-65*SW G10/G20-85*SW G20-A0*SW
a 250 450 600
G10/G20-**1SW G10/G20-**4SW
b 180 420
c -27.5 212.5
d 420 660