Electrolux 316488521 - Manual (Page 12)

12 12 12 12 12
Step 15 Step 15 Step 15 Step 15 Step 15
WIRING THE HOOD
WIRING THE HOOD WIRING THE HOOD WIRING THE HOOD WIRING THE HOOD
Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 V
120 V 120 V 120 V 120 VAC, 15 or 20 Amp cir AC, 15 or 20 Amp cir AC, 15 or 20 Amp cir AC, 15 or 20 Amp cir AC, 15 or 20 Amp circuit r cuit r cuit r cuit r cuit requir equir equir equir equired. ed. ed. ed. ed.
ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failur
Failur Failur Failur Failure to do so can r e to do so can r e to do so can r e to do so can r e to do so can result in death or electrical esult in death or electrical esult in death or electrical esult in death or electrical esult in death or electrical
shock. shock. shock. shock. shock.
• If not already done, install 1/2” conduit connector
in j-box.
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2” conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover.
Step 16 Step 16 Step 16 Step 16 Step 16
Final installation steps
Final installation steps Final installation steps Final installation steps Final installation steps
Replace filters and install the lamps as described in
the Care & Use section of this manual.
Note:
Note: Note: Note: Note: Lamps are not supplied, use ONLY 120 Volt,
50 Watt (maximum) 50° halogen light made for a
GU10 base, suitable for use in open luminarie
suitable for use in open luminarie suitable for use in open luminarie suitable for use in open luminarie suitable for use in open luminarie.
Turn power on at service panel.
Check operation of the hood.
IMPORTANT: If the hood doesn’t switch ON, before
calling for service, check if the internal General ON/
OFF Pushb-utton Switch is switched ON.
Installing the hood
General ON/OFF
Push button Switch
Back side of the hood
Front side of the hood