Eclipse - Fujitsu Ten CD5423 - Manual (Page 78)

78
How to operate the receiver with an optional DSP/EQ unit connected
Fine-tuning EQ functions
Press the [SEL] button until the desired equalizer mode
is displayed.
Turn the [SEL] button to switch frequencies.
The frequencies will switch in the following sequence: 2
1
Press the [SEEK /FAST ] button to adjust the level.
[SEEK ] button: Increases the value.
[FAST ] button: Decreases the value.
Hold down a button, [1] to [6], for more than two
seconds to preset a value. 4
3
Press the [RTN] button.
At this time, other adjustments can also be made in Sound
Adjustment Mode.
Press the [SOUND] button to exit Sound Adjustment
Mode.
This cancels the adjustment mode. The selected value will
now take effect. 6
5
63Hz 125Hz 250Hz 500Hz 1kHz 4kHz 12kHz
ATTENTION
When the preset value is changed, the display shows as follows:
USER
1~6 (Preset ch No.)
[SOUND] button [SEEK ] button Buttons [1] to [6]
[SEL]
button
[FAST ] button
[RTN] button