Emerson Radio iE600BK - Manual (Page 25)

24
NOTES:
A.) Use the Manual Tuning method to tune to weak stations that are bypassed
during Automatic Tuning.
B.) During Automatic Tuning if the tuner does not stop on the exact frequency
of your station, for example, the display shows FM 103.55 instead of
FM 103.5 - use the Manual Tuning method to “fine tune” up or down to the
exact frequency.
C.) If you are listening to a very weak FM Stereo station, try pressing the
Radio/Band button to select the FM MONO mode. This will normally
improve the reception although the sound will no longer be in stereo.
3.) Adjust the Volume, EQ or Bass/Treble, and Surround controls as desired.
4.) When you are finished listening press the Power button to shut the system
‘Off’. The display lighting and edge lighting go off and the display changes from
radio frequency to the correct time, month and date display.
NOTE: The system remembers the last station you were listening to, plus
the Volume and EQ settings you selected before switching the power off,
and automatically returns to those same settings when the radio is switched
on again.
Antenna Information
AM
The AM bar antenna is inside the cabinet. It may be necessary to adjust the position
of the cabinet until the internal antenna is receiving the strongest possible signal.
FM
Make sure that the FM wire antenna is firmly attached to the screw terminal on the
bottom cabinet. It may be necessary to adjust the position of the FM wire antenna
to find the position that provides the best FM reception.
iE600_050407.p65 4/5/2007, 11:50 24