Epson 850N - Manual (Page 154)

Using Floppy Diskettes
A-5
Installing EPSON Net! in Windows
1. Insert the EPSON Net! diskette in your drive.
2. In Windows 95 or NT 4.0, click Start , then click Run .
In Windows 3.1x, select Run from the File menu in
Program Manager.
3. For NetWare, type A:\WINDOWS\INSTALL and click OK .
(If your diskette drive is not A, substitute the correct letter.)
For NT and TCP/IP, type A:\WNT\INSTALL and click
OK . (If your diskette drive is not A, substitute the correct
letter.)
4. Follow the instructions on the screen to complete the
installation.
After you install EPSON Net!, you can use it to configure your
printer for NetWare (on page 16 in your Setup Guide) or for
NT and TCP/IP (on page 23 in your Setup Guide).
Installing EPSON Net! on a Macintosh
1. Create a folder for EPSON Net! on your hard disk.
2. Insert the EPSON Net! diskette in your drive.
3. Double-click the diskette to open it and copy EPSON Net!
to the folder you created.
After you install EPSON Net!, you use it to configure your
printer for AppleTalk, as described on page 23 in your Setup
Guide.
Note:
For peer-to-peer networks
with both Windows NT
and Windows 95, use
EPSON Net! on a
Windows NT system.
If you have a peer-to-peer
network with only
Windows 95, you use
TCP/IP and EPSON TCP/IP
(included with Status
Monitor 2) to configure the
Ethernet card and use the
printer on the network.
See the
Setup Guide .
basket-a.fm Page 5 Wednesday, May 13, 1998 4:09 PM