LG Studio 30 Inch Smart Double Electric Wall Oven Owners Guide User Manual
Page 46
46
MAINTENANCE
NOTE
• The oven should be level to ensure that the
bottom surface of the oven cavity is entirely
covered by water at the beginning of the
EasyClean
cycle.
• For best results, use distilled or filtered water.
Tap water may leave mineral deposits on the
oven bottom.
• Soil baked on through several cooking cycles will
be more difficult to remove with the
EasyClean
cycle.
• Do not open the oven door during the
EasyClean
cycle. Water will not get hot enough if
the door is opened during the cycle.
1
Remove oven racks and accessories from the
oven.
2
Scrape off and remove any burnt-on debris
with a plastic scraper.
• Suggested plastic scrapers:
- Hard plastic spatula
- Plastic pan scraper
- Plastic paint scraper
- Old credit card
3
Fill a spray bottle (10 oz or 300 ml) with water
and use the spray bottle to thoroughly spray
the inside surfaces of the oven.
4
Use at least 1/5 (2 oz or 60 ml) of the water in
the bottle to completely saturate the soil on
both the walls and in the corners of the oven.
5
Spray or pour the remaining water (8 oz or
240 ml) onto the bottom center of the oven
cavity. The indentation on the oven bottom
should be fully covered to submerge all soils.
Add water if necessary.
NOTE
• If cleaning multiple ovens, use an entire bottle of
water to clean each oven. Do not spray water
directly on the door. Doing so will result in water
dripping to the floor.
6
Select the
UPPER OVEN
or
LOWER OVEN
and
touch
Clean
in the Cooking Modes screen.
Touch
EasyClean
in the display.
7
Touch
Start
. The remaining time appears in
the display.
CAUTION
• Some surfaces may be hot after the
EasyClean
cycle. Wear rubber gloves while cleaning to
prevent burns.
• During the
EasyClean
cycle, the oven becomes
hot enough to cause burns. Wait until the cycle is
over before wiping the inside surface of the
oven. Failure to do so may result in burns.
• Avoid leaning or resting on the oven door glass
while cleaning the oven cavity.
8
A tone will sound at the end of the 10 minute
cycle. Touch
End of the Cleaning
in the
display to end the EasyClean mode and the
tone.
9
After the cleaning cycle and during hand-
cleaning, enough water should remain on the
oven bottom to completely submerge all soils.
Add water if necessary. Place a towel on the
floor in front of the oven to capture any water
that may spill out during hand-cleaning.
10
Clean the oven cavity immediately after the
EasyClean
cycle by scrubbing with a wet, non-
scratch scouring sponge or pad. (The scouring
side will not scratch the finish.) Some water
may spill into the bottom vents while
cleaning, but it will be captured in a pan under
the oven cavity and will not hurt the burner.
UUGGwG[]GGm SGq GYZSGYWYXGGZaY^Gwt