Gas conversion, Ba c – Fisher & Paykel Series 7 Contemporary Series 30 Inch Freestanding Gas Range Installation Guide User Manual
Page 23
23
!9
GAS CONVERSION
Adjusting the cooktop burner minimums
When switching from one type of gas to another, the minimum flow rate must also be correct:
●
The flame should not go out even when passing suddenly from maximum to minimum flame.
To regulate the flame follow these instructions:
Semi-rapid burner (
A
)
●
Light the burner.
●
Set the gas valve to
position (minimum rate).
●
Remove the dial.
●
With a thin screwdriver, turn the regulation screw inside the tap rod until adjustment is correct.
Inside crown of DUAL burner (
B
)
●
Light the DUAL burner.
●
Set the gas valve to
position (minimum rate of inner crown).
●
Remove the dial.
●
With a thin screwdriver, turn the regulation screw until adjustment is correct.
The screw is accessible via a hole in the microswitch.
Outside crown of DUAL burner (
C
)
●
Light the DUAL burner.
●
Set the gas valve to
position (minimum rate of outer crown and maximum rate of inner crown).
●
Remove the dial.
●
With a thin screwdriver, turn the regulation screw inside the tap rod until adjustment is correct.
For LP/PROPANE gas, tighten the adjustment screws completely.
A
Regulation screw (Semi-Rapid burner)
B
Regulation screw (Inner crown of dual burner)
C
Regulation screw (Outer crown of dual burner)
B
A
C
Regulation
screws
Regulation
screws
Regulation
screws