beautypg.com

Maintenance – Samsung 30 Inch Slide-in Gas Smart Range Owner Manual User Manual

Page 32

background image

32 English

Maint

enanc

e

Maintenance

Burner grates and components

Turn off all surface burners and make sure they have all cooled down.

1

2

3

L

C

R

1.

Remove the center burner grate(C)
following both sides grates.(L/R)

2.

Remove the burner caps from the burner
heads.

3.

Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.

4.

Clean all removable grates and burner
components in warm, soapy water. Do
not use steel-wool pads or abrasive
cleaners.

5.

Rinse and dry grates and burner
components thoroughly.

8

7

6

6.

Return the burner heads to their
positions on top of the manifold valves.
Make sure a starter electrode is inserted
through the hole in each burner head.

NOTE

See the next page for detailed burner
component re-assembly instructions.

7.

Return the burner caps to their positions
on top of the burner heads. To ensure
proper and safe operation, make sure the
burner caps lie flat on top of the burner
heads.

8.

Reinstall the burner grates in their
respective positions.

9.

Turn on each burner and check if it
operates properly. After verifying that a
burner operates normally, turn it off.

NOTE

After cleaning, confirm that the burner port openings aren't plugged.

Do not wash any burner components in a dish washer.

CAUTION

The starter electrodes are not removable. Do not attempt to remove them by
force.

To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.

The burner spreader can be blocked by food or dust. Clean the spreader if it
appears blocked. If you clean the spreader with water, assemble it only after it is
completely dry. If the spreader is wet, it might prevent the burners from igniting.

To avoid falling down the grates, make sure to remove both sides grates first.

Burner reinstall guide

Round burner head

1.

Orient the burner head so that the
opening for the electrode lines up with
the electrode.

2.

Install the burner head so that the
electrode passes through the opening for
the electrode. Make sure the burner head
lies flat on the stove top.

NX60T8111SS_AA_DG68-01223A-00_EN+MES+CFR.indb 32

2020-03-27 11:51:17