Samsung 30 Inch Freestanding Electric Smart Range Owner Manual - Manual (Page 38)

38 English
Oper
ating the o
v
en
Operating the oven
Baking
Bake is used to cook cakes, cookies, and casseroles. Always preheat the oven first.
Baking temperatures and times will vary depending on the ingredients and the
size and shape of the baking pan used. Dark or nonstick coatings may cook faster
with more browning.
How to set the temperature
1.
To use Twin mode, insert the divider. If you are using Single mode, skip this
step.
2. Press Bake . the default temperature is 350 °F.
3. Enter the temperature you want on the number pad eg. 3, 7, 5.
4. Press START/SET . The temperature display will start to change once the oven
temperature reaches 175 °F.
5. If you want to cancel baking or if baking is complete, press OFF/CLEAR .
(Press OFF/CLEAR on the Lower/Single oven control side if you are using Twin
mode.)
NOTE
• Place food in the oven after preheating if the recipe calls for it.
• Preheating is very important for good results when baking cakes, cookies,
pastry, and breads. After the oven has reached the desired temperature, the
oven will beep several times.
• If you are using an oven thermometer in the oven cavity, the temperature
registered by the thermometer may differ from the actual set oven
temperature.
• For performance reasons, the convection fan may be turned on or off during
the operation.
How to adjust the temperature while cooking
1.
Start the setup.
Press
Bake . The display will show the present temperature, eg. 375 °F.
2. Enter the temperature you want, eg. 425 °F, using the number pad.
3. Complete the entry by pressing START/SET .
The process is the same in Twin Mode.
Using the divider
• To use twin mode operation, insert the divider.
• You cannot use the Self-Clean or Steam-Clean functions when the divider is
installed in the oven cavity.
• Handle the divider with both hands.
• Use oven gloves when inserting or removing the divider.
To Install the divider into the Oven Cavity
1. Insert the divider into the 4th rack
position of the cavity.
2. Push the divider in until its back end
rests against the back of the cavity.
CAUTION
Range displays "-dC-"
•
Check the divider to see if it is installed correctly.
NOTE
You can store the divider into the storage drawer.