Epson MediaLink Controller MLC 104 IP Plus User Manual
Mlc 104 ip plus, Setup guide, Medialink
Table of contents
Document Outline
- Chapter One
- Introduction
- Chapter Two
- MLC 104 IP Plus Hardware Setup
- Chapter Three
- MLC 104 IP Plus Software Setup
- Step 1: Download Device Drivers
- Step 2: Create a New Project
- Step 3: Add an MLC 104 IP Plus Controller and Define its Location
- Step 4: Define E-mail Settings
- Step 5: Add a Serial and an IR Device
- Step 6: Configure the Front Panel Buttons
- Step 7: Configure the Control Modules Using the Auto Fill Feature
- Step 8: Create a Display Shutdown Schedule
- Step 9: Create a Display Lamp Hour Warning E-mail
- Step 10: Create a Display Disconnection E-mail
- Step 11: Build and Upload a Configuration