beautypg.com

Sharp 1.1 cu. ft. Over-the-Range Convection Microwave Oven Owner's Guide User Manual

Page 30

background image

C L E A N I N G A N D C A R E

FAN

The fan will automatically start when heat rises from

range surface units or burners and when convection, high

mix, low mix or the broil settings are used. This protects

the microwave oven from excessive temperature rise.

The fan will stay on until the temperature decreases. It

cannot be turned off manually during this time.
For other uses, select either high or low speed.
PRECAUTIONS FOR PROPER USE:

CHARCOAL FILTER

Charcoal Filter, Sharp Part Number RK-220 is used for

No-vented, recirculated installation. The

lter should be

changed every 6 to 12 months depending on use.

OVEN LIGHT

Remove the louver per instructions 1-4 above and

charcoal filter, if used.

LIGHT

CAUTION: Light cover may become very hot. Do not

touch glass when light is on. Do not use light for long

time use such as a night light.

Screw

Top tab

Charcoal filter

Screw

Screw

Light cover

Oven light

Louver

Screw

Light bulbs

Bottom tab

27

1. Disconnect power to the oven at the circuit breaker

panel or by unplugging.

2. Remove 3 screws that secure louver.
3. Remove louver by inserting

at edge screwdriver

over each tab depressing the tab down and moving

louver away from unit.

4. Pull the louver away from the oven.
5. Slide Charcoal Filter into position on support tabs.
6. Push louver back into place and gently snap tabs into

place by hand (engaging both the bottom and top

tabs) and replace the 3 screws to secure louver.

1. DO NOT leave range unattended while using high

temperatures. Automatic fan may start and provide

excessive air to the surface units. This may cause

spattering or boilover.

2. Avoid burning food.
3.

Keep grease filters clean.

1. To replace light bulbs,

first

disconnect power to the

oven at the circuit breaker panel or by unplugging.

2. To release cover remove the screw on the light cover.

(See illustration.)

3. Replace bulbs only with equivalent watt bulbs

available from a Sharp Authorized Servicer or parts

distributor. Bulbs are also available at most hardware

stores or lighting centers. DO NOT USE A BULB

LARGER THAN 30 WATTS.

4. Close light cover and secure with screw removed in

step 2.

5. Slide the light cover forward and lift up.
6. Remove old light bulb and replace only with

an equivalent watt bulb available from a Sharp

Authorized Servicer or parts distributor. Bulbs are

also available at most hardware stores or lighting

centers. DO NOT USE A BULB LARGER THAN 30

WATTS.

7. Replace the oven light cover and charcoal

lter,

if used; push louver back in place (engaging both

the bottom and top tabs) and replace the louver

mounting screws.