Rating label, Model numbers, Regulatory / code requirements – Hestan 30 Inch Drawer Microwave Installation Manual User Manual

Page 4

RATING LABEL

The rating plate includes model and serial number. Open the Drawer Microwave fully. The label is

beyond the back wall of the drawer facing up from the bottom surface.
If service is necessary, contact Hestan

Customer Care with the model and serial

number information shown on the label.

MODEL NUMBERS

MODEL NO.

DESCRIPTION

CIRCUIT BREAKER

KMWR30

30” Drawer Microwave

15 Amps

All units 115 VAC 60 Hz

Hestan Commercial Corporation
3375 E. La Palma Ave
Anaheim, CA 92806

TYPICAL RATING LABEL

Installation of this cooking appliance must be made in accordance with local codes. In the absence

of local codes, this unit should be installed in accordance with the National Electrical Code and

local codes.
This appliance must be electrically grounded in accordance with local codes or in the absence of

local codes with the National Electrical Code ANSI/NFPA 70, or Canadian Electrical code CSA

C22.1.

IMPORTANT NOTES

UNPACKING YOUR DRAWER MICROWAVE

• Remove all packing materials from inside the Drawer

Microwave. DO NOT REMOVE THE WAVEGUIDE COVER,

which is located on the top of the Drawer Microwave.

• Remove the feature sticker, if there is one. Check the drawer

for any damage, such as misaligned or bent drawer, damaged

drawer seals and sealing surfaces, broken or loose Drawer

Microwave guides and dents inside the cavity or on the front

side of the drawer. If there is any damage, do not operate

the Drawer Microwave and contact your dealer or a HESTAN

AUTHORIZED SERVICER.

IMPORTANT NOTES TO THE INSTALLER

• Read all of the Installation Manual before installing the Drawer

Microwave.

• Remove all packing material before connecting the electrical

supply.

• Observe all governing codes and ordinances.
BE SURE TO LEAVE THESE INSTRUCTIONS WITH THE CONSUMER.

Waveguide

cover

Sealing
surface

Sealing

surface

Oven

cavity