Enviro C-11366 - Manual (Page 26)

26
Secondary Installation
Figure 45: Rock Placement of Four Large Rocks. Figure 46: Rock Placement of Two Medium Rocks.
Figure 47: Rock Placement of Seven Small Rocks.
Figure 48: Rock Placement Complete.
3. The four (4) large rocks are placed across front
of burner (see Figures 45 & 46). These rocks
are all the same shape, but must be rotated
in different positions to fit in the cut-aways in
the burner base. When there installed correctly,
there should be no visible gaps between the
rocks and the burner base. The gaps between
the rock cluster and the four (4) large rocks
needs to be maintained as smaller gaps will lead
to carbon deposits and build up.
4. Place the two (2) medium rocks; one on either
side of the cluster as shown in Figures 46 &47.
These rocks can not be placed down between
the others.
5. Addition the seven (7) small rocks. These can be
NOTES:
a. Some sooting on the rocks is normal. The
sooting should just be a thin covering in some
places on the center three (3) rocks of the
rock cluster. There should not be continuous
build up.
b. Surface cracks may appear after prolonged
use. This is due to the expansion and
contraction of materials during heating
cycles. Surface cracks are not a problem as
long as the assemblies are maintaining there
positions, and operation does not appear to
be altered.
added in some fashion like what’s shown in Figures 47 & 48 with three (3) on the top row with the
larger one in the center and two (2) smaller ones on either side.
7. Check that the rock set is laid out as shown in Figure 48 and install door.
8. Light the unit to enure it has a good flame (see Front Cover).
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED.