Enviro C-11366 - Manual (Page 25)

25
I
NSTALLATION OF
R
OCK
S
ET
:
If the rocks are positioned incorrectly, the flames can be “pinched” and will not burn correctly. If the rocks
are broken due to handling or shipping, replace the rocks with new ones. Using the pictures provided,
carefully set the rocks in place.
Secondary Installation
Important note: When the unit is
turned on for the first time, it should
be turned onto high without the fan
on for the first four (4) hours. This will
cure the paint, logs, gasket material
and the other products used in the
manufacturing process. It is advisable
to open a window or door, as the unit
will start to smoke and can irritate
some people. After the unit has gone
through the first burn turn the unit off
including the pilot, let the unit get cold
then remove the glass door and clean it
with a good gas fireplace glass cleaner,
available at your local ENVIRO dealer.
See M
AINTENANCE
A
ND
S
ERVICE
on how to
remove door to clean glass.
Figure 43: Cara DR with a Good Flame.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED.
NOTE: The rocks are fragile, particularly
after usage. Please handle with due care
during servicing.
1. Carefully remove rocks from box and check
there is no damage. It is very important to
install all rocks in their proper position to
ensure safe, optimum operating conditions.
2. Place the rock cluster onto the burner. There
are two (2) pins on the back of the burner and
two (2) holes in the bottom of the rock cluster
(refer to Figures 44 & 45).
Figure 44: Installation of Rock Cluster.