Epson 4113114-06 - Manual (Page 94)

Troubleshooting 94
Stacker 3 is not correctly inserted for External
Output Mode (when stacker 3 is set as the
output stacker) or Batch Mode
Make sure stacker 3 is correctly inserted.
Stacker 1 is empty
Load discs into stacker 1.
Note:
The Stacker lamp flashes when the
source stacker is out of discs; however,
the timing of the light flashing may not
match the timing of the stacker
becoming empty.
Stacker 2 is empty
Load discs into stacker 2.
Note:
The Stacker lamp flashes when the
source stacker is out of discs; however,
the timing of the light flashing may not
match the timing of the stacker
becoming empty.
Stacker 1 is overloaded
Remove discs so that discs are below the red
line.
Stacker 2 is overloaded
Remove discs so that discs are below the red
line.
Stacker 3 is overloaded
Remove all the discs from stacker 3.
Stacker 2 is full
Remove published discs from stacker 2.
Stacker 3 is full
Remove published discs from stacker 3.
Stacker 4 is full
Remove published discs from stacker 4.
Stacker 4 is open
Close stacker 4.
Lights
Conditions/Remedies
Power Busy Error Ink
Stacker
1 2 3 4