Epson 4113114-06 - Manual (Page 69)

Publishing Discs 69
c Caution:
❏ Do not open the covers while the product is publishing discs, unless the application
instructs to add or remove discs. This may affect write quality or print quality. Also, for
safety reasons, do not put your hands inside the product while it is beeping, as arm is still
moving.
❏ Beep will sound if you open disc cover while running a job, and the job will pause. Closing
the disc cover automatically resumes the job.
❏ Do not operate the stacker while the unit is beeping, as the arm may be damaged.
❏ If you need to open the covers, pause or cancel your job before opening it.
❏ Depending on the disc or the computer used, writing speed may become slower than the
set speed.
❏ Depending on the disc used, the recommended writing speed of the disc cannot be used.
In this case, reduce the writing speed. Especially with DVD±R DL, it is recommended to
write with slow speed.
Note:
If Windows shuts down while processing a job, the job may be resumed when restarting Windows
next time.
Taking Out Discs
Follow the steps below to take out the published discs from the stackers.
c
Caution:
If you select stacker 4 as the output stacker in Standard Mode or External Output Mode,
❏ Do not yank stacker 4 when pulling it out to remove published discs.
❏ Do not pull out stacker 4 when the stacker 4 LED is flashing fast. Discs may be damaged.
1. Open the disc cover (only for output to stacker 2 or 3), and take out the stacker.
2. Take out the published discs from the stacker. The output stacker differs according to
the publishing mode. Refer to the following table.
Output stacker Mode Number of discs
Stacker 2 Standard Mode
Batch Mode
Up to about 50 discs
Stacker 3 External Output Mode
Batch Mode
Up to about 50 discs