Vivotek FD9388-HTV 5MP Outdoor Network Dome Camera with Night Vision - Manual (Page 375)

VIVOTEK
User's Manual - 375
© 2019 VIVOTEK INC. All Right Reserved
242
PARAMETER VALUE DESCRIPTION
function zoom,
focus,
auto,
scan,
stop,
positioning,
irisopen,
irisenable,
getstatus Function type
zoom - Move focus motor
focus – Move focus motor
auto – Perform auto focus
scan – Perform focus scan
stop – Stop current operation
positioning – Position the motors
irisopen – Fully open iris. It will maintain fully open iris status
until sending function=irisenable cgi.
irisenable – return back to user setting status of iris.
getstatus–Information of motors, return value as below:
remote_focus_zoom_motor_max : Maximum steps of zoom
motor
remote_focus_focus_motor_max : Maximum steps of focus
motor
remote_focus_zoom_motor_start : Start point of zoom motor
remote_focus_zoom_motor_end : End point of zoom motor
remote_focus_focus_motor_start : Start point of effective focal
length
remote_focus_focus_motor_end : End point of effective focal
length
remote_focus_zoom_motor : Current position of zoom motor
remote_focus_focus_motor : Current position of focus motor
remote_focus_zoom_enable : Current function of zoom motor
remote_focus_focus_enable : Current function of focus motor
remote_focus_iris_open : The current status of iris. 0: irisenable,
1: irisopen
Current function of zoom/focus motor, return value as below:
0: no service
1: zooming
2. focusing
3: auto focus
4: focus scan
5: positioning (both zoom motor and focus motor)
12: reset focus
© 2019 VIVOTEK INC. All Right Reserved
243
PARAMETER VALUE DESCRIPTION
direction direct,
forward,
backward Motor’s moving direction.
It works only if function=zoom or function=focus.
position 0~ Motor’s position.
It works only if function=zoom or function= focus and
direction=direct.
is refer to remote_focus_focus_motor_max or
remote_focus_zoom_motor_max which replied from
"function=getstatus"
steps 1 ~ Motor’s moving steps.
It works only if function=zoom or function=focus and
direction=forward and direction=backward.
is refer to remote_focus_focus_motor_max or
remote_focus_zoom_motor_max which replied from
"function=getstatus"
* This parameter is for additional fine-tune, the value is from 1 to
30.
iris N/A Open iris or not.
It works only if function=auto or function=scan.