Vivotek FD9388-HTV 5MP Outdoor Network Dome Camera with Night Vision - Manual (Page 339)

VIVOTEK
User's Manual - 339
© 2019 VIVOTEK INC. All Right Reserved
206
NAME VALUE SECURITY
(get/set) DESCRIPTION
The dwelling time of each patrol point,
separated by “,”
preset_i<0~(k-1)>_nam
e string[40] 1/4 Name of the preset location.
preset_i<0~(k-1)>_
dwelling 0 ~ 999 1/4 The dwelling time of each preset
location
uart 0 ~ "
capability_nuar
t"-1 1/4 Select corresponding uart
(capability_nuart>0).
cameraid 0~255 1/4 Camera ID controlling external PTZ
camera.
isptz 0 ~ 2 1/4 0: disable PTZ commands.
1: enable PTZ commands with PTZ
driver.
2: enable PTZ commands with UART
tunnel.
* Only available when bit7 of
capability_ptzenabled is 1
disablemdonptz 1/4 Disable motion detection on PTZ
operation.
7.41 Camera PTZ Control (IZ Series)
Group: camctrl_c<0~(n-1)> for n channel products (capability_camctrl_c0_zoommodule = 1 and
capability_camctrl_c0_buildinpt = 0)
n denotes the value of "capability_nvideoin" and k denotes the value of "capability_npreset"
NAME VALUE SECURITY
(get/set) DESCRIPTION
ccdtype string[16] 6/7 (Internal used, read only)
motortype string[16] 6/7 (Internal used, read only)
cameraid 0 ~ 255 1/4 Camera ID controlling external PTZ
camera.
Note:
Please set your speed dome to the
appropriate baud rate, and Camera ID,
e.g. 2400bps, camera ID 1,2,3,,,,etc.
© 2019 VIVOTEK INC. All Right Reserved
207
NAME VALUE SECURITY
(get/set) DESCRIPTION
All Camera IDs on the same controlling
system (NVR or rs485 keyboard) have to
be distinct.
Therefore, once you send a controlling
signal, each camera will only accept the
inputs with the corresponding ID.
panspeed -5 ~ 5 1/4 Pan speed
tiltspeed -5 ~ 5 1/4 Tilt speed
zoomspeed -5 ~ 5 1/4 Zoom speed
autospeed -5 ~ 5 1/4 Auto pan speed
focusspeed -5 ~ 5 1/4 Auto focus speed
focusmode auto,onetimeau
to,spotlight,ma
nual
* Available
values are
listed in
"capability_cam
ctrl_c<0~(n-1)>
_focusmode" 1/4 Indicate the focus control mode.
uart 0 ~
"capability_nua
rt"-1 1/4 Select corresponding uart
(capability_nuart>0).
isptz 0 ~ 2 1/4 0: disable PTZ commands.
1: enable PTZ commands with PTZ
driver.
2: enable PTZ commands with UART
tunnel.
* Only available when bit7 of
capability_ptzenabled is 1
preset_i<0~(k-1)>_name string[40] 1/4 Name of the preset location.
preset_i<0~(k-1)>_zoom capability_ptz_
c<0~(n-1)>_min
zoom ~
capability_ptz_
c<0~(n-1)>_ma
1/4 Zoom position at each preset location.