EnGenius Technologies ENH500 User Manual

Page 74

11.4 Client Router Mode

In the Client Router Mode, the ENH500 has a DHCP Server that allows multiple devices to
share the same Internet connection. Connect to an AP/WISP wirelessly and connect to LANs
via wired. Client Router Mode is functionally opposite to the AP Router Mode.

Please refer to the last section to check Access point’s configuration.

Client Router

Step 1

Step 2

Select your country or region’s regulation.

Step 3

Select Operation Mode to Client Router from System
Properties.

Step 4

Change your Local Area Network setting to Obtain an IP
Address Automatically.

Step 5

Use site survey to scan channels of the nearby area.

Step 6

Select the AP that you would like to associate with.

Step 7

Setup the authentication settings that match the Access Point’s
settings.

Step 8

Configure your WAN connection type which is given by your
Internet Service Provider on the WAN Settings.

Step 9

Press Apply to process all of the configurations.

The Client Router’s IP settings must match those of the Access Point’s.

ENH500

AP / WISP

192.168.1.1

192.168.1.10

192.168.1.11

192.168.1.12