EnGenius Technologies ENH500 - Manual (Page 10)

1.6 Understanding the ENH500 LEDs
The rear of the ENH500 has two groups of LEDs. One group, labeled INDICATORS, shows the
status of the device. The second group, LINK QUALITY, shows the strength of the link
between the ENH500 and the network. The following table describes the ENH500 LEDs.
LED Color Mode Status
Power Green OFF= ENH500 is not receiving power.
ON= ENH500 is receiving power.
LAN Green OFF = ENH500 is not connected to the network.
ON = ENH500 is connected to the network, but not sending or
receiving data.
Blink = ENH500 is sending or receiving data.
WLAN Green Access Point
or Client
Bridge
Mode OFF = ENH500 radio is off and the device is not
sending or receiving data over the wireless LAN.
ON = ENH500 radio is on, and the device is not
sending or receiving data over the wireless LAN.
Blink = ENH500 radio is on, and the device is
sending or receiving data over the wireless LAN.
Link Quality See Status column Access Point
or Client
Bridge
Mode
Shows the strength of the link between the
ENH500 and the network.
G = good quality (green).
Y = medium quality (yellow).
R = poor or no link (red).