EnGenius Technologies ENH500 - Manual (Page 53)

Internet Connection
Type
Select Static IP to begin configuration of the Static IP connection.
Account Name Specify Account Name that is provided by ISP.
Domain Name Specify Domain Name that is provided by ISP.
MTU Specify the Maximum Transmit Unit size. EnGenius recommends
that it remains in Auto.
IP Address Specify WAN port IP address.
IP Subnet Mask Specify WAN IP Subnet Mask.
Gateway IP Address Specify WAN Gateway IP address.
Primary DNS Specify Primary DNS IP.
Secondary DNS Specify Secondary DNS IP.
Discard Ping on WAN Place a check to Enable or Disable ping from WAN.
Accept / Cancel
Press Accept to confirm the changes or Cancel to return
previous settings.
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 4.1 for more information.
If the router's MTU is set too high, downstream packets will be fragmented. If
the router's MTU is set too low, the router will fragment packets unnecessarily and, in extreme
cases, may be unable to establish connections. In either case, network performance can suffer.