EnGenius Technologies ENH500 - Manual (Page 66)

10.3 SNMP Settings
Click on the SNMP Settings link under the Management menu. This is a networking
management protocol used to monitor network-attached devices. SNMP allows messages
[called protocol data units] to be sent to various parts of a network. Upon receiving these
messages, SNMP-compatible devices [called agents] return data stored in their Management
Information Databases.
SNMP Enable/Disable Select the Radio button to Enable or Disable SNMP function.
Contact
Specify the contact details of the device.
Location Specify the location of the device.
Community Name Specify the password for access the SNMP community for read
only access.
Community Name Specify the password for access the SNMP community for read
and write access.
Trap Destination IP
Address Specify the IP address that will receive the SNMP trap.
Trap Destination
Community Name Specify the password of the SNMP trap community.
Save / Apply / Cancel Press Save / Apply to confirm the changes or Cancel to return
previous settings.
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 4.1 for more information.