Epson B 500DN - Manual (Page 28)

B-300/B-500DN User’s Guide
Paper Handling 28
Note:
❏ The thickness of envelopes and their ability to fold vary widely. If the total thickness of the stack of
envelopes exceeds 15 mm, press down on the envelopes to flatten them before loading. If print quality
declines when a stack of envelopes is loaded, load one envelope at a time.
❏ You can load up to 15 envelopes at a time in the rear sheet feeder.
❏ Do not use envelopes that are curled or folded.
❏ Flatten the envelope flaps before loading.
❏ Flatten the leading edge of the envelope before loading.
❏ Avoid using envelopes that are too thin, as they may curl during printing.
For printing instructions, see the following instructions.
&
See “Printing on Envelopes” on page 38.
Setting Output Tray
The output tray is located on the front paper cassette. Slide out the extension tray and then open
the flap on the extension tray to prevent your prints from slipping off the printer.
Setting output support tray for Epson Professional Flyer Paper
When you print on the Epson Professional Flyer Paper, set the output support tray. The use of the
output support tray is recommended especially when the output paper is curled and cannot be
stacked. Follow these steps to set the output support tray.