CHAUVET DJ Helicopter Q6 - Rotating Multi-Effects Light with Laser (RGBW) - Manual (Page 20)

Page 14 of 94
Operation
Helicopter Q6 User Manual Rev. 2
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Automatic Programs
To run the Helicopter Q6 in automatic mode, follow the instructions below:
1. Press repeatedly until P-- shows on the display.
2. Press .
3. Use or to select an automatic program, from P 1–10 .
4. Press .
Auto-Program Speed
To change the auto-program speed on the Helicopter Q6, do the following:
1. Press repeatedly until S-- shows on the display.
2. Use or to increase or decrease the program speed, from S 01–99 .
3. Press .
Sound-Active Mode
To run the Helicopter Q6 in sound-active mode, follow the instructions below:
1. Press repeatedly until Snd shows on the display.
2. Press .
3. Use or to select a sound-active program, from Sn 1–10 .
4. Press .
5. Turn the sensitivity knob up until the product responds to the beat of the music.
Static Color Mode
To run the Helicopter Q6 on a static color, do the following:
1. Press repeatedly until C-- shows on the display.
2. Press .
3. Use or to select a static color, from C 1 (red), C 2 (green), C 3 (blue), or C 4
(white).
4. Press .
Rotation Mode
To control the direction and speed of the rotation when in static color mode, follow the instructions below:
1. Press repeatedly until Moto shows on the display.
2. Press .
3. Use or to select a rotation direction, from di-L (left) or di-r (right).
4. Press .
5. Use or to increase or decrease the rotation speed, from S 0–99 .
6. Press .
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
The product will only respond to low frequencies of music (bass and drums).