Mounting, Orientation, Rigging – CHAUVET DJ Helicopter Q6 - Rotating Multi-Effects Light with Laser (RGBW) User Manual
Page 15: Proper usage, Setup mounting
Page 9 of 94
Helicopter Q6 User Manual Rev. 2
Setup
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
Orientation
The Helicopter Q6 must be mounted in a position that includes planning for safe laser usage.
Rigging
•
Before deciding on a location, always make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure adequate ventilation is provided around the product.
•
Make sure that the structure or surface onto which you are mounting the product can support the
product’s weight. (see the
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
Mounting Diagram
Proper Usage
This product is for overhead mounting only. For safety purposes, Chauvet recommends mounting lighting
effect products on steady elevated platforms or sturdy overhead supports using suitable hanging clamps.
In all cases, use safety cables. Obtain appropriate mounting hardware from your lighting vendor.
International laser safety regulations require that laser products must be operated in the fashion illustrated
below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and the lowest laser
light. Additionally, 3 meters of horizontal separation is required between laser light and audience or other
public spaces.
CAUTION! Use of controls, adjustments, or procedures other than THOSE specified
IN THIS USER MANUAL may result in hazardous radiation exposure.
Mounting Bracket
Safety Cable
(such as
CH-05
from
Chauvet)
Mounting Clamp
(such as
CLP-15
from Chauvet)