Setup, Ac power, Fuse replacement – CHAUVET DJ Helicopter Q6 - Rotating Multi-Effects Light with Laser (RGBW) User Manual
Page 14: Power linking
Page 8 of 94
Setup
Helicopter Q6 User Manual Rev. 2
3. Setup
AC Power
The Helicopter Q6 has an auto-ranging power supply and it can work with an input voltage range of 100 to
240 VAC, 50/60 Hz. To determine the product’s power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s
. The listed current rating indicates the product’s average current draw under
normal conditions.
Fuse Replacement
1.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
2.
Pry the fuse holder out of the housing.
3.
Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4.
Insert the fuse holder back in place and reconnect power.
Power Linking
The product provides power linking via the Edison outlet located in the back of the product. Please see the
diagram below for further explanation.
Power Linking Diagram
•
Always connect the product to a protected circuit (a circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Disconnect the product from the power outlet before replacing the fuse.
You can power link up to 12 Helicopter Q6 products on 120 VAC or up to 23
Helicopter Q6 products on 230 VAC.
The power linking diagram corresponds to the North American version of the
product ONLY! If using the product in other markets, you must consult with the local
Chauvet distributor as power linking connectors and requirements may differ in
your country or region.
Safety cap
Spare fuse holder
(inside safety cap)
Installed fuse
(held by plastic clip)
1
st
Product
3
rd
Product
Additional
Products
Power
Source
2
nd
Product